Topcon Pocket-3D Reference Manual page 121

3. On the Point(s) dialog box (Figure 3-18), do the following to
import points, then press Next:
• None – enable to display no points.
• All points – enable to display all points in the project.
• Selected points only – available only if points are highlighted
(selected) on the main screen.
• Points by layer – enable to select a layer to import from the
drop-down list
Figure 3-18. Select Points to Export for the Project
4. On the Control data dialog box (Figure 3-19 on page 3-12), do
the following to export control point data, then press Next:
• Control point(s) – check mark this box to export control
points.
• Localization – check mark this box to export localization
data.
• MMGPS Transmitter(s) – check mark this box, when
available, to export MMGPS transmitter data.
P/N 7010-0628
Project
3-11