Options - Topcon Pocket-3D Reference Manual

(Figure 4-82).

Options

To view or change options for stake-out measurements, tap
SurveyStake-outOptions (Figure 4-83).
On the stakeout options dialog box, select the desired options for
stakeout measurements, cut sheet, and audio, then press Ok
(Figure 4-84 on page 4-56).
sets the way to measure/stake-out points and alignments
Measure tab
and the information to display on the main screen during a
measurement/stake-out.
• Press ENTER to measure – enable to use the Enter key (on the
controller's casing, below the display screen) to start the
measurement on each stakeout point or alignment.
P/N 7010-0628
Figure 4-82. Vertical Surface Offset
Figure 4-83. SurveyStake-outOptions
Stake-out
4-55