Table of Contents
Advertisement
• If either or both Axis measurements are more than 10'', disconnect
from the sensor and connect to the transmitter.
• Press Finish to upload the adjustments to the transmitter. When
finished uploading, the transmitter will apply the adjustments and
turn off.
TIP
NOTE
Edit Channel
To edit information for the selected transmitter, tap the Edit Channel
button on the Channel tab (Figure 2-33 on page 2-24).
On the edit channel dialog box, edit and select the following
parameters and press Ok to save (Figure 2-33 on page 2-24).
1. Transmitter – select the desired transmitter from the drop-down
list.
2. Control point – select the control point for the transmitter's
position from the drop-down list.
P/N 7010-0628
After loading the new self-leveling offset data into
the transmitter, re-calibrate to check the system.
The transmitter may need to be calibrated a couple
of times depending on site conditions.
Figure 2-32. Adjustment Results
This process only applies an offset to the self-
leveling mechanism to ensure correct grade. The
control point file is not affected.
mmGPS Applications
2-23
Advertisement
Table of Contents
