Surface Offset - Topcon Pocket-3D Reference Manual

Survey Menu
On the Slope Options dialog box, enter parameters to calculate the
target point, then press Ok (Figure 4-81 on page 4-54).
• Insert 1st Stake at – select either Cut/Fill or Dist from Daylight to
calculate the 1st stake's position.
– 1. Cut/Fill: enter the desired cut value between the slope and
the current position.
The target point will be set at the position where this cut
value is the same as that from the slope to the current
position.
– 2. Dist from Daylight: enter a horizontal distance that
represents the desired distance from the daylight point to the
1st stake.
• 3. Offset to 2nd stake – enter the desired horizontal distance from
Measure Stake 1 to Measure Stake 2.
Figure 4-81. SurveyStake-outSlopesOptions
The Image tab illustrates the measurements described on the Slope
Options tab.
V. Surface Offset
To add an extra vertical surface offset to a point or surface file, tap
SurveyStake-outV. Surface Offset. On the small pop-up
keyboard, enter the value for the extra vertical offset, then press Ok
4-54
Pocket-3D Reference Guide