Table of Contents
Advertisement
Setup Menu
• Usage – select either H. Angle only, H.&V. Angles, H.,V. Angles &
SD., or Disabled to specify how the control point will be used.
• HT – enter the height of the control point's prism.
• PC – enter the prism constant of the control point's prism.
• H.Angle – enter the horizontal angle difference.
• V.Angle – enter the vertical angle difference.
• S.Dist – enter the slope distance difference.
• Observe – press to measure the control point.
Control Points dialog
Unknown point
point 1.
1. On the Setup method dialog box
enter instrument height and unit of measurement as described
above, (page 2-38) then press Next.
The Station coordinates dialog box displays (Figure 2-58 on
page 2-43).
2. The Station coordinates dialog box (Figure 2-58 on page 2-43)
verifies the North(ing), East(ing), and Elev(ation) for the new
control point.
2-42
Figure 2-57. Backsight Results
automatically creates this point in the database as
Backsight Results dialog
Figure 2-56 on page 2-41
(
Pocket-3D Reference Guide
,
)
Advertisement
Table of Contents
