Dell Networking N4000 Series Configuration Manual page 617

Command
interface
interface
name
ip access-group
direction seqnum
CTRL + Z
show ip access-lists
name
[ ]
Purpose
(Optional) Enter interface configuration mode for the
specified interface. The
interface type and number, for example tengigabitethernet
1/0/3.
You can also specify a range of interfaces with the interface
range command, for example, interface range
tengigabitethernet 1/0/8-12 configures interfaces 8, 9, 10,
11, and 12.
Bind the specified ACL to an interface.
NOTE:
To apply this ACL to all interfaces, issue the command
in Global Configuration mode.
name
• — Access list name. (Range: Valid IP access-list
name up to 31 characters in length)
direction
• — Direction of the ACL. (Range: In or out.
in
Default is .)
seqnum
• — Precedence for this interface and direction. A
lower sequence number has higher precedence. Range: 1
– 4294967295. Default is1.
Exit to Privileged EXEC mode.
Display all IPv4 access lists and all of the rules that are
defined for the IPv4 ACL. Use the optional
parameter to identify a specific IPv4 ACL to display.
Configuring Access Control Lists
interface
variable includes the
name
617