Preconfiguring A Stack Member - Dell Networking N4000 Series Configuration Manual

SW Management
Status
--- ---------
1 Stack Member
3 Mgmt Switch
4 Stack Member

Preconfiguring a Stack Member

To preconfigure a stack member before connecting the physical unit to the
stack, use the show support switchtype command to obtain the SID of the
unit to be added.
The example in this section demonstrates pre-configuring a Dell Networking
switch on a stand-alone Dell Networking switch.
To configure the switch:
1 View the list of SIDs to determine which SID identifies the switch to
preconfigure. The following is the output on N3000 and N2000 series
switches.
console#show supported switchtype
SID
--- --------------------------------
1 N3024
2 N3024F
3 N3024P
4 N3048
5 N3048P
6 N2024
7 N2024P
8 N2048
9 N2048P
NOTE:
N2000 and N3000 switches cannot be stacked together.
Standby Preconfig
Status Model ID
------- --------
N3048
N3048
N3048
Switch Model ID
Plugged- Switch
in Model Status
ID
-------------------
N3048 OK
N3048 OK
N3048 OK
Managing a Switch Stack
Code
Version
--------
6.0.0.0
6.0.0.0
6.0.0.0
197