Configuring Dcbx - Dell Networking N4000 Series Configuration Manual

no lldp tlv-select dcbxp ets-recommend
no lldp tlv-select dcbxp pfc
These commands eliminate only the DCBX TLVs from use by LLDP. They do
not otherwise affect any manually configured DCBX capabilities or the
normal operation of LLDP.

Configuring DCBx

You can use the CLI to configure DCBX on N4000 switches.
Beginning in Privileged EXEC mode, use the following commands to
configure DCBx.
Command
configure
lldp dcbx version {auto
| cin | cee | ieee}
lldp tlv-select dcbxp
[pfc | application-
priority]
interface
interface
Purpose
Enter global configuration mode.
Optionally configure the administrative version for the
DCBx protocol:
• auto—Automatically select the version based on the peer
response (default)
• cin—Force the mode to Cisco-Intel-Nuova. (DCBx 1.0)
• cee—Force the mode to CEE (DCBx 1.06)
• ieee—Force the mode to IEEE 802.1Qaz
Enable LLDP to send specific DCBx TLVs if LLDP is
enabled to transmit on the given interface. Entering the
command with no parameters enables transmission of all
TLVs.
• pfc—Transmit the PFC configuration TLV
• application-priority—Transmit the application priority
TLV
Enter interface configuration mode for the specified
interface
interface. The
and number, for example tengigabitethernet 1/0/3.
You can also specify a range of interfaces with the interface
range command, for example, interface range
tengigabitethernet 1/0/8-12 configures interfaces 8, 9, 10,
11, and 12.
Configuring Data Center Bridging Features
variable includes the interface type
997