Monitoring System Information And Configuring Logging (Cli); Viewing System Information And Enabling The Locator Led - Dell Networking N4000 Series Configuration Manual

Monitoring System Information and Configuring
Logging (CLI)
This section provides information about the commands you use to configure
information you use to monitor the Dell Networking N2000, N3000, and
N4000 series switches. For more information about these commands, see the
Dell Networking N2000, N3000, and N4000 Series Switches CLI Reference
Guide
at support.dell.com/manuals.

Viewing System Information and Enabling the Locator LED

Beginning in Privileged EXEC mode, use the following commands to view
system health and resource information and to enable the switch locator
LED.
Command
show system
show system power
show system
temperature
show memory cpu
show process cpu
unit
locate [switch
time
[time ]
Command
show system
show system power
show system
temperature
show memory cpu
Purpose
Display various system information.
Displays the power supply status.
Displays the system temperature and fan status.
Displays the total and available RAM space on the switch.
Displays the CPU utilization for each process currently
running on the switch.
] Enable the switch locator LED located on the back panel
of the switch. Optionally, you can specify the unit to
identify within a switch stack and the length of time that
the LED blinks.
Purpose
Display various system information.
Displays the power supply status.
Displays the system temperature and fan status.
Displays the total and available RAM space on the switch.
Monitoring and Logging System Information
267