Dell Networking N4000 Series Configuration Manual page 927

Command
mode
hashing-mode
CTRL + Z
show interfaces port-
port-channel
channel [
number
]
show statistics port-
port-channel-
channel
number
Configuring LACP Parameters
Beginning in Privileged EXEC mode, use the following commands to
configure system and per-port LACP parameters.
Command
configure
lacp system-priority
value
Purpose
Set the hashing algorithm on the LAG.
mode
The value is a number from 1 to 7. The numbers
correspond to the following algorithms:
• 1 — Source MAC, VLAN, EtherType, source module, and
port ID
• 2 — Destination MAC, VLAN, EtherType, source
module, and port ID
• 3 — Source IP and source TCP/UDP port
• 4 — Destination IP and destination TCP/UDP port
• 5 — Source/destination MAC, VLAN, EtherType, and
source MODID/port
• 6 — Source/destination IP and source/destination
TCP/UDP port
• 7 — Enhanced hashing mode
Exit to Privileged EXEC mode.
View LAG information for the specified LAG or for all
LAGs.
View interface statistics for the specified LAG.
Purpose
Enter global configuration mode.
Set the Link Aggregation Control Protocol priority for the
switch. the priority value range is 1–65535.
Configuring Link Aggregation
927