Dell Networking N4000 Series Configuration Manual page 690

Command
dvlan-tunnel ethertype
{802.1Q | vman |
0-65535
custom <
[primary-tpid]
CTRL + Z
show dvlan-tunnel
show dvlan-tunnel
interface
interface {
all}
690
Configuring VLANs
Purpose
Configure the EtherType to use for uplink or access
interfaces.
>}
• 802.1Q — Configures the EtherType as 0x8100 (default).
• vman — Configures the EtherType as 0x88A8.
• custom — Custom configures the EtherType for the
DVLAN tunnel. The value must be 0-65535.
• primary-tpid — Configure the primary (outer) TPID. If
this parameter is not present, the inner TPID is
configured. Only a single outer TPID may be configured
for a switch. The inner VLAN TPID can be configured on
all interfaces or on individual interfaces.
Exit to Privileged EXEC mode.
Display all interfaces enabled for Double VLAN Tunneling
Display detailed information about Double VLAN
| Tunneling for the specified interface or all interfaces.