Dell Networking N4000 Series Configuration Manual page 571

Command
block
CTRL + Z
show captive-portal
cp-id
configuration
[status | interface]
show captive-portal
interface configuration
cp-id
status
NOTE:
To return the default Captive Portal instance to its default values, use the
clear command in the Captive Portal Instance mode. You must also use the no
interface
interface
instance.
Configuring Captive Portal Groups and Users
Beginning in Privileged EXEC mode, use the following commands to create a
Captive Portal group. You can use the default group, or you can create a new
group.
Command
configure
captive-portal
Purpose
(Optional) Block all traffic for a Captive Portal
configuration. If the Captive Portal is blocked, users
cannot gain access to the network through the Captive
Portal. Use this function to temporarily protect the
network during unexpected events, such as denial of
service attacks.
Exit to Privileged EXEC mode.
View summary information about a Captive Portal
instance.
cp-id
• — The Captive Portal instance (Range: 1–10).
• status — View additional information about the Captive
Portal instance.
• interface — View information about the interface(s)
associated with the specified Captive Portal.
View information about the interfaces associated with the
specified Captive Portal instance.
cp-id
— The Captive Portal instance (Range: 1–10).
command to remove any associated interfaces from the
Purpose
Enter global configuration mode.
Enter Captive Portal mode.
Configuring Port and System Security
571