Dell Networking N4000 Series Configuration Manual page 404

4 Create a setup file named dellswitch.setup. The setup file contains
the following lines:
001E.C9AA.AC17 switchA.txt N2000vR.5.4.1.stk
001E.C9AA.AC20 switchB.txt N2000vR.5.4.1.stk
001E.C9AA.AC33 switchC.txt N2000vR.5.4.1.stk
NOTE:
However, the
files can contain the commands required to configure a static IP address on
each switch. Otherwise, the switch will use DHCP to attempt to acquire an IP
address.
5 Copy the dellswitch.setup file to the USB device.
6 Connect the USB device to Switch A.
7 Connect Switch A to the network. Make sure that a port (OOB port for
out-of-band management or any switch port for in-band management) is
connected to the network and that a DHCP server is accessible on the
network.
8 Insert the USB device into the USB port on the front panel of Switch A.
9 Power on Switch A. If no startup-config file is found, the Easy Startup
wizard will begin. Press N to skip the Easy Startup wizard and the USB
Auto Configuration process will begin. If necessary, delete the startup-
config file and reboot the switch.
The configuration in switchA.txt file is downloaded to the switch,
and the management interface acquires network information. After the
process completes, a message displays to indicate the status. The
dellswitch.setup file is updated to add the term in-use to the
end of the line. The N2000vR.5.4.1.stk image is also downloaded
to the switch.
10 Remove the USB device from Switch A and insert it into Switch B.
11 Repeat the process to connect a port to the network. Power on the switch
to begin the USB Auto Configuration process on Switch B.
12 Remove the USB device from Switch B after the process completes, and
repeat the steps to perform the USB Auto Configuration process on
Switch C.
404
Auto Image and Configuration Update
This .setup file does not provide the switch with a static IP address.
switchA.txt
,
switchB.txt,
and
switchC.txt