Dell Networking N4000 Series Configuration Manual page 922

Figure 28-5. LAG Membership
Adding a Port to a Static LAG
To add a static LAG member:
1 Open the LAG Membership page.
2 Click in the LAG row to toggle the port to the desired LAG.
The LAG number displays for that port. The LAG number increases each
time you click until the number reaches the maximum LAG number and
then returns to blank (no LAG assigned).
3 Click Apply.
The port is assigned to the selected LAG, and the device is updated.
Adding a LAG Port to a Dynamic LAG by Using LACP
To add a dynamic LAG member:
1 Open the LAG Membership page.
2 Click in the LACP row to toggle the desired LAG port to L.
NOTE:
LACP.
3 Click Apply.
The LAG port is added as a dynamic LAG member to the selected LAG.
922
Configuring Link Aggregation
The port must be assigned to a LAG before it can be aggregated to an