Configuring Iscsi Optimization (Cli) - Dell Networking N4000 Series Configuration Manual

Configuring iSCSI Optimization (CLI)

This section provides information about the commands you use to configure
iSCSI settings on the switch. For more information about the commands, see
Dell Networking N2000, N3000, and N4000 Series Switches CLI
the
Reference Guide
Command
configure
tcp-port-1
iscsi target port
tcp-port-2...tcp-port-16
[
ip-address
[address
targetname
]
at support.dell.com/manuals.
Purpose
Enter Global Configuration mode. iSCSI
optimization is enabled by default.
Configure an iSCSI target port and, optionally,
] address and name.
] [name
tcp-port-n
•
numbers on which the iSCSI target listens to
requests. Up to 16 TCP ports can be defined in the
system in one command or by using multiple
commands.
ip-address
•
the no form of this command is used, and the tcp
port to be deleted is one bound to a specific IP
address, the address field must be present.
targetname
•
name can be statically configured; however, it can be
obtained from iSNS or from sendTargets response.
The initiator must present both its iSCSI Initiator
Name and the iSCSI Target Name to which it wishes
to connect in the first login request of a new session
or connection.
—TCP port number or list of TCP port
—IP address of the iSCSI target. When
—iSCSI name of the iSCSI target. The
Configuring iSCSI Optimization
471