Viewing Slot Information (N4000 Series Only); Configuring Poe Settings (N2024P/N2048P And N3024P/N3048P Only) - Dell Networking N4000 Series Configuration Manual

Viewing Slot Information (N4000 Series Only)

Use the following commands to view information about Slot 0 and its
support.
Command
show slot
show supported cardtype Display information about the modules the switch

Configuring PoE Settings (N2024P/N2048P and N3024P/N3048P Only)

Beginning in Privileged EXEC mode, use the following commands to
configure PoE information.
Command
configure
power inline usage-
threshold
threshold
power inline
management {class |
static | dynamic}
power inline detection
{dot3af |
dot3af+legacy}
interface
interface
power inline {auto |
never}
Purpose
Display status information about the expansion slots.
supports.
Purpose
Enter Global Configuration mode.
Specify the maximum usage for PoE power on the system.
threshold
The variable (range: 1–99%) is a percentage of
total system power.
Set the power-management mode for the switch.
Set the power-management mode for the switch.
• 802.3af-only—IEEE 802.3af detection scheme is used.
• 802.3af+legacy—IEEE 802.3af 4point detection scheme
is used and when it fails to detect a connected PD, legacy
capacitive detection is used.
Enter interface configuration mode for the specified port.
interface
The variable includes the interface type and
number, for example gigabitethernet 1/0/3.
Set the PoE device discovery admin mode.
• auto — Enables the device discovery protocol and, if
found, supplies power to the device.
• never — Disables the device discovery protocol and stops
supplying power to the device.
Managing General System Settings
313