Configuring And Viewing Additional Network Information - Dell Networking N4000 Series Configuration Manual

Static IP subnets on inband ports (configured on switch VLANs) may not
overlap with the OOB port subnet. If configuring management access on the
front-panel ports, it is recomended that:
• A VLAN other than the default VLAN be used to avoid attack vectors
enabled by incorrect cabling.
• Both ACLs and Management ACLs be utilized to reduce the possibility of
DoS attacks or intruders gaining access to the switch management
console. The advantage of the management ACL is that it can also protect
the OOB port, whereas ACLs can only protect access via an in-band port.
Command
configure
interface vlan 1
ip_address
ip address
subnet_mask
prefix/prefix-length
ipv6 address
[eui64]
ipv6 enable
exit
ip default-gateway
ip_address
ipv6 gateway
exit
show ip interface vlan 1
show ipv6 interface vlan 1

Configuring and Viewing Additional Network Information

Beginning in Privileged EXEC mode, use the following commands to
configure a DNS server, the default domain name, and a static host name-to-
address entry. Use the show commands to verify configured information and
to view dynamic host name mappings.
164
Setting Basic Network Information
Purpose
Enter Global Configuration mode.
Enter Interface Configuration mode for VLAN 1.
Enter the IP address and subnet mask.
Enter the IPv6 address and prefix.
Enable IPv6 on the interface.
Exit to Global Configuration mode
ip_address
Configure the default gateway.ipv6 gateway
Configure the default gateway for IPv6.
Configure the default gateway for IPv6.
Exit to Privileged Exec mode.
Verify the network information for VLAN 1.
Verify IPv6 network information for VLAN 1.