Configuring Lldp-Med Settings - Dell Networking N4000 Series Configuration Manual

Configuring LLDP-MED Settings

Beginning in Privileged EXEC mode, use the following commands to
configure LLDP-MED settings that affect the entire switch.
Command
configure
lldp med
faststartrepeatcount
count
interface
interface
lldp med
lldp med
confignotification
lldp med transmit-tlv
[capabilities] [network-
policy] [location]
[inventory]
exit
exit
show lldp med
show lldp med interface
interface
{all | }
Purpose
Enter Global Configuration mode.
Specifies the number of LLDP PDUs that will be
transmitted when the protocol is enabled.
Enter interface configuration mode for the specified
Ethernet interface.
Enable LLDP-MED on the interface.
Allow the port to send topology change notifications.
Specify which optional TLVs in the LLDP MED set are
transmitted in the LLDP PDUs.
Exit to Global Config mode.
Exit to Privileged EXEC mode.
View global LLDP-MED settings.
View LLDP-MED settings for all ports or for the specified
port.
Discovering Network Devices
781