Configuring Green Features - Dell Networking N4000 Series Configuration Manual

Command
link-dependency group
group_id
interface
add
interface
depends-on
action {down|up}
CTRL + Z
show link-dependency
group_id
[group

Configuring Green Features

Beginning in Privileged EXEC mode, use the following commands to
configure and monitor energy-saving features for the ports and the switch.
Command
configure
498
Configuring Port Characteristics
Purpose
Enter the link-dependency mode to configure a link-
dependency group.
Add member ports to the group.
interface
The
number, for example tengigabitethernet 1/0/3. You can
also add port-channels (LAGs) as members by using the
keyword port-channel followed by an ID.
You can also specify a range of interfaces. For example,
interface tengigabitethernet 1/0/8-10,1/0/20 configures
interfaces 8, 9, 10 and 20.
Specify the port(s) upon which the member ports are
dependent. For information about the
see the previous command description.
Specifies the action the member ports take when the
dependent link goes down.
• down—When the dependent link is down, the group
members are down (the members are up otherwise).
• up—When the dependent link goes down, the group
members are brought up (the members are down
otherwise)
Exit to Privileged EXEC mode.
View link dependency settings for all groups or for the
] specified group, along with the group state.
Purpose
Enter Global Configuration mode.
variable includes the interface type and
interface
variable,