Outside Mirror-Removal And Installation; Seats-Removal And Installation; Front Seat; Rear Seat - Jeep cherokee 1989 Owner's Manual

11-14
20.2 Remove the retaining screw, pull out the trim cover
loosen the adjustment knob set screw (2) and detach
the panel from the door
-
20 Outside mirror removal and installation
Refer to illustration 20.2, 20.3 and 20.5
Standard mirror
1 Remove the door trim panel (see Section 12).
2 Remove the retaining screw, pull out the trim cover, loosen the
adjustment knob set screw and pull off the trim cover (see illustration).
3 Remove the three retaining bolts and lift off the mirror (see illus-
tration).
4 Installation is the reverse of removal.
Low profile mirror
5 Remove the three retaining bolts and lower the mirror assembly
from the vehicle (see illustration).
6 Installation is the reverse of removal.
I
20.5 The low profile mirror (1) is retained by three bolts (2)
The Motor Manual Guy
Chapter 11 Body
20.3
21 Seats
Refer to illustrations 2 1.2, 2 1.4a, 2 1.4b and 2 1.7

Front seat

1 Remove the seat frame trim panels.
Remove the retaining nuts, unplug any electrical connectors and
2
lift the seats from the vehicle (see illustration).
3 Installation is the reverse of removal. Tighten the retaining nuts
t o the specified torque.

Rear seat

Bottom cushion
4 Pull up on the bottom cushion release strap, tilt the cushion for-
ward, then unlock the frame release lever and lift the assembly out
(see illustrations).
21.2
Three bolts (arrows) retain the mirror to the door
-
removal and installation
The front seats are retained by four nuts (arrows)