Set Mode Schedule - Panasonic S-ics Technical Manual

Section 700 - Operation
7. Enter the Message Key ID code.
Notes: The ID code may contain up to 16 digits and contain
0, 1-9, *, #, pause (REDIAL key).
To clear an entry or existing data, press the FL/R key.
8. Press the HOLD key to store the entry.
9. To set additional Message Key ID codes, press the volume
up or down key or press the HOLD key to move to the
desired extension.
10. Repeat steps 7-9 until all Message Key ID codes are set.
11. Press the MEMORY key to exit the entry mode.
12. To return to the top menu level (81), press the PROG key.
OR...
To exit the User Maintenance mode, press the ON/OFF
key.
Hardware Requirements
• N/A
Considerations
• N/A

Set Mode Schedule

Description
(For a description of Automatic Day/Night System Mode, see "Automatic Day/Night Mode" on page
38.)
You can set the System to automatically enter None, Day 1, Day 2, Night, Night (1), or Night (2)
modes based upon mode patterns. You can define up to 3 patterns with up to 5 modes for each day.
(This menu allows the setting of the patterns.)
Operation
To set the Mode Schedule:
1. If not already in User Maintenance mode, enter User Main-
tenance mode. (See "To enter User Maintenance mode:" on
page 79.)
2. At the 81 level, enter 07.
3. Press the HOLD key.
S-ICX-64-700
Action
Action
S-ICX (International) issued April 2002
Chapter 4. User Maintenance
Result
Next extension number displays
Desired extension number displays
MSGID - EXT Number displays
81-
User MAINT displays
OR...
ON/OFF LED goes off
Result
81-
User MAINT displays
8107-
System Mode displays
91