Table of Contents
Advertisement
Chapter 5. Key Telephone Features
Floating Hold
Floating Hold is a type of System Hold that allows you to retrieve a held call from any extension that
has an FF key assigned to the same Floating Hold orbit where the call is held. You can also retrieve a
call by dialling the Floating Hold orbit number for the held call.
Floating Hold is useful when the intended recipient of a call must be located via a page. The call can
be placed in a Floating Hold "orbit" and that orbit number announced during the page. The paged
party can then pick up the call by dialling the orbit number or by pressing an FF key assigned to that
orbit number.
Note: To place a call on Floating Hold, you should have at least one FF key assigned to a Floating
Hold orbit number.
Operation
To place a call on Floating Hold:
1. While on a call, press the Floating FF key (system program-
ming required) or press the HOLD key.
To retrieve a call from Floating Hold:
1. (A) Press the FF key assigned to the Floating Hold orbit
number where the call is held.
OR...
(A) Enter the Floating Hold Answer feature access code
(default = *9).
(B) Enter the Floating Hold orbit number 01-96 (CPC-HS/
HM) or 01-09 (CPC-HS/HM) (See considerations below.)
Hardware Requirements
•
N/A
Considerations
•
The number of floating hold orbits available may very depending on the Station/Floating Park
Hold Pickup setting (FF1-0-02-0025). The call pickup access code can set to *9 (default). The
"*9" access code operates as follows:
System Size
S-ICX
134
Action
Action
Virtual Line Number and Operation
01-09: Floating Hold pick up
10-96: For Station Park Hold pick up purpose
S-ICX (International) issued April 2002
Section 700 - Operation
Result
• Intercom dial tone
• Hold CO XXX displays (where XXX
= outside line number)
Result
CO XXX displays if line released (where
XXX = outside line number)
S-ICX-64-700
Advertisement
Table of Contents
