SERVICE PROGRAM MODE
15. SERVICE PROGRAM MODE
15.1 ACCESS PROCEDURE 1-KEY OPERATION
1. Turn on the main switch.
2. Enter "71" by using the number keys.
3. Press and hold the
the Copy Counter and then release it.
4. Press the
NOTE: "5" will blink in the Copy Counter to show that the SP mode has
been accessed.
5. Enter the desired SP mode number using the number keys. The SP
mode numbers are given in the Service Program Mode Table.
NOTE: "1" is displayed in the Manual ID indicator (as shown below)
instead of "1" in the Copy Counter when SP mode numbers over
"100" are entered. The maximum number is "111".
6. Press the
NOTE: To enter a different SP mode number, press the
7. To leave SP mode, open and close the front cover or turn the main switch
off and on.
A202/A203
key until a dot (•) appears in the top left corner of
key again and then press the
: "1"
A203M500.wmf
key to view the current setting.
key.
8-34
Rev. 5/30/97
key.
SM