[A]
[B]
[C]
A662I508.img
11. Locate the 4P connector [A] and connect it to the ADF interface board [B],
then attach the ADF interface unit [C] to the copier (1 screw) while
securing the harnesses through the wire clamp.
NOTE: Use the screw that secured the ADF bracket. (See the previous
page.)
12. Plug the connector [D] (3P/Black) into CN418 on the ac drive board [E] as
shown.
13. Reinstall the upper rear cover.
14. Plug the optics fiber cable [F] into the DF and the copier as shown.
15. Plug the DF power supply cord [G] into the outlet in the rear of the copier
as shown.
16. Open the front cover.
17. Lift up the upper unit.
CAUTION
Be sure to place and hold your left hand on top of the upper unit while
pushing the release lever to the right with your right hand. The upper
unit will raise with force, and holding the upper unit will prevent it
from lifting too rapidly.
SM
[D]
8-31
[E]
INSTALLATION
[F]
[G]
A662I509.img
A202/A203