INSTALLATION
14. Do the developer initial setting procedure.
1) Plug in the machine and turn on the main switch, then lower the platen
cover.
2) Enter the SP mode as follows:
a) Enter "71" using the number keys.
b) Press and hold the
corner of the copy counter.
c) Release the
d) Press the
3) Operate SP 65 as follows.
SP Mode Number
Developer Initial Setting
65
(Continue to next page.)
A202/A203
key until a dot (•) appears in the top left
key and again press the
key, then input 65 with the number keys.
Enter "65" using the number keys and press the
key. "50" will be displayed in the copy counter.
Press the
about 5 minutes.
8-26
key again.
Procedure
key to start the initial setting. It takes
Rev. 5/30/97
SM