Ricoh A151 Field Service Manual page 257

[C]
[G]
[H]
5. Insert the DF [A] into the holes [B] in the copier upper cover.
6. Secure the DF to the copier (2 thumb screws [C]).
7. Remove the upper rear cover [D] (2 screws).
8. Remove the ADF bracket [E] (1 screw and 1 clamp).
9. Locate the 4P connector [F] and connect it to the ADF interface board
[G], then fix the ADF interface unit [H] to the copier (1 screw) while
securing the harnesses through the wire clamp.
NOTE: Use the screw that secured the ADF bracket [I].
10. Plug in the connector [J] (3P/Black) to CN418 on the ac drive board [K].
FSM
[A]
[B]
[F]
[K]
[J]
7-5
[I]
[D]
[E]
[H]
A151/A152