Ricoh A151 Field Service Manual page 266

5.6 PICK-UP SOLENOID ADJUSTMENT
[B]
1. Turn off the main switch.
2. Remove the feed-in unit. (See Feed-in Unit Removal.)
3. Loosen two screws [A] securing the pick-up solenoid [B].
4. Place a 1.2 mm thickness gauge [C] between the plunger and the
solenoid.
5. Turn the solenoid lever [D] clockwise until the plunger touches the
thickness gauge. Just at this point, tighten two screws.
6. Make sure that the pick-up lever [E] is touching the pick-up roller [F]
when the plunger is pushed. If not, repeat steps 3 to 5.
7. Reassemble the DF.
8. Turn on the main switch and check the original feed-in operation.
A151/A152
[A]
[C]
7-14
[F]
[D]
[E]
FSM