Change Adjustment Values Or Modes - Ricoh A151 Field Service Manual

Access Procedure 2 - Using DPS101-2
1. Turn the main switch off.
2. Remove the upper rear cover and turn on DPS101-2, then turn on the
main switch. "5" will blink in the Copy Counter.
3. Enter the desired SP mode number by the numeral keys. SP mode
numbers are given in the Service Program Mode Table.
4. Press the Auto Image Density key to view the data.
5. To leave SP mode, turn off DPS101-2.
NOTE: To cancel an already entered SP mode, press the Auto Image
Density key.

2.1.2 Change Adjustment Values or Modes

1. Follow the steps from 1 to 6 in Access Procedure 1 or the steps from 1 to
4 in access procedure 2.
2. The factory-set or the default setting will be displayed in the
Magnification indicator (FT3213 copier) or in the Copy Counter (FT3013
copier).
3. Enter the desired value or mode using the numeral keys and then press
the Auto Image Density key. (SP mode data are given in the Service
Program Mode Table.)
4. To leave SP mode, open/close the front cover or turn off/on the main
switch (Access Procedure 1) or turn off DPS 101-2 (Access Procedure 2).
FSM 4-9 A151/A152