Ricoh A151 Field Service Manual page 256

4. INSTALLATION PROCEDURE
NOTE: 1) This procedure is for the FT3213 copier only.
[E]
CAUTION: When installing the DF, make sure that the copier is
unplugged.
1. Remove the platen cover [A] from the copier.
2. Replace the 2 screws with the 2 stud screws [B].
3. Remove the strips of tape from the DF.
CAUTION: This procedure (step 4) must be done only in 240 volt areas
4. Perform the conversion from 220∼230 V to 240 V as follows:
1) Remove the main board cover [C] (2 screws).
2) Disconnect the connector for 220∼230 V [D] (Black Wire) from the ac
harness connector [E] and reconnect the connector for 240 V [F]
(White Wire) to the ac harness connector.
3) Reinstall the cover.
A151/A152
[B]
[C]
7-4
[A]
[F]
230~240 V
[D]
220~230 V
Rev. 1/95
FSM