[F]
[D]
9. Remove the lower rear cover [A] (2 screws).
10. While turning the main motor [B] clockwise (viewed from the front), turn
the feed rollers [C] until you can remove the feed roller screws [D].
11. Remove three feed roller screws (1 screw each).
12. Remove the feed rollers from the shaft [E] while pushing them up with
your hands as shown.
NOTE: When reinstalling the feed rollers, make sure that they are positioned
on the opposite side of the spring pin [F] as shown. Otherwise, the
six feed rollers will be positioned incorrectly.
A151/A152
[B]
[C]
5-36
[A]
[E]
[C]
FSM