Ricoh A151 Field Service Manual page 270

No. Item
Electrical Component
Fusing Triac
1
Power Distribution
Quenching
Lamp
1
Paper Feed
Paper Length
Detection for
Paper Tray Unit
1
Installation
Document
Feeder (A662)
1
SP Modes
Display of SP
Mode Number
1
Which are
Above 100
Software
Counters
2
Clear All
Memory
3
Procedures
A202/A203
A202/A203
The fusing triac is built
into the ac drive board for
all models.
The quenching lamp
receives dc power from
the main board.
The paper length is
measured by the
registration sensor during
every first copy.
The document feeder
can be installed on the
FT4015 (A219) as well.
When installing, make
sure to use the correct
interface unit bracket.
The manual ID indicator
is used instead of "1" in
the copy counter.
Some software counters
are eliminated due to the
small capacity of the
EEPROM.
The clear all memory
procedure can be
performed by key
operation.
2
A151/A152
In the 115V machines,
the fusing triac is a
separate electrical
component.
The quenching lamp
receives ac power from
the ac drive board.
The paper length is
measured by the
registration sensor only
during the first copy after
some particular actions
are performed.
-
"•" is displayed instead of
"1" in the copy counter.
The copier uses a RAM
Pack for the software
counters.
The clear all memory
procedure can be
performed by DPS101-2
only.
SM