Rev. 7/97
Mode No.
Horizontal Edge
Margin Width
Adjustment
80
Factory
81
Initialization
Toner End
Counter Clear
83
Energy Saving
Ratio
86
V
Correction
L
Reset
95
Toner End
Force Cancel
96
Service Call
(E5) Reset
97
Clear Counters
98
Clear All
Memory
99
SM
Function
Selects whether the side erase mechanism
changes when the optional document feeder is
installed.
Compared with the platen mode erase, the next
inmost LED block will turn on to erase.
Factory use only.
Do not change the setting.
Clears the toner end counter (SP58). Resets the
used toner overflow condition (E70) if it is
detected.
This mode must be performed when the used
toner tank is cleaned.
Selects the energy saving ratio.
The greater the saving ratio, the longer the
waiting time until the copier returns to the ready
condition.
Saving Ratio
Waiting Time
0: 56%
25 s
1: 47%
19 s
2: 37%
12 s
3: 25%
5 s
Resets the exposure lamp setting and counter
for the V
correction.
L
Before performing this mode, clean the optics
parts. After performing this mode, perform SP48
and SP56.
The Toner End condition is canceled forcibly.
By pressing the
key to enter this SP mode,
the toner end condition is canceled.
Resets a service call (E5) condition.
Turn the main switch off and on to check if the
service call condition is reset.
Clear the following counters:
Copy counters
SC counters
Misfeed counters
To clear, enter "1" then press the
the
key at the same time.
To avoid resetting the counter by mistake, the
counter is reset only when the
key are pressed at the same time.
Clear all counters and returns all modes to the
default settings. See the Clear All Memory
Procedure in this section for more details.
To clear, enter "1" then press the
the
key at the same time.
To avoid resetting the counter by mistake, the
counter is reset only when the
key are pressed at the same time.
8-43
SERVICE PROGRAM MODE
0: Always stays
in Platen Mode
1: DF Mode
0: No
1: Yes
0: 56%
1: 47%
2: 37%
3: 25%
0: No
1: Yes
0: Default
1: Reset
0: No
1: Yes
key and
key and the
0: No
1: Yes
key and
key and the
Settings
A202/A203