[2]
[3]
[A]
6. Put the bead of the dark silver wire [3] in slot [A], directly below the slot
that holds the end of the light silver wire [2].
7. Put the bead of the light silver wire [4] in the other slot [B], directly below
the slot that holds the end of the dark silver wire [1].
8. Wind the dark silver wire [3] clockwise one and a half times around the
pulley. Wind the light silver wire [4] once clockwise around the pulley.
9. Slide the omega clamp [C] down to secure all the wires as shown.
NOTE: a) The dark and light silver wires alternate on the pulley with the
dark silver wire uppermost.
b) Wires are not wound around the two grooves shown in the
illustration (rear view [D]).
c) Wires are wound around all the grooves shown in the
illustration (front view [E]).
10. Set the pulley on the drive shaft (1 E-ring).
A151/A152
[1]
[4]
[3]
[4]
[B]
[C]
5-16
[E]
[D]
[1]
[3]
[4]
[2]
SM