Stepper Motor (Exit) Assembly And Belt (Exit) Removal - Lexmark C950 Service Manual

Reinstallation notes:
The tension of the belt (entrance/paddle) (B) is automatically adjusted by the force of the spring attached to
•
the belt tensioner bracket (A).
Tighten the two screws in the order shown.
•

Stepper motor (exit) assembly and belt (exit) removal

1. Remove the rear upper cover. See
Loosen the two screws securing the belt tensioner bracket (A) to the finisher, and move it down as shown.
2.
Remove the belt (exit) (B) from the stepper motor (exit) (C).
3.
Disconnect the connector from the stepper motor (exit).
4.
Second
5. Remove the two screws securing the bracket (D) to the finisher.
Remove the bracket (D).
6.
"Rear upper cover removal" on page
B
A
A
First
4-306.
C
Connector
Rear
Repair information
5058-030
Previous
Next
Go Back
4-345