15.02
VT100 SETUP & CONFIGURATION
Follow these steps for setting up VT100 Mode:
•
Power off your TEK-AT4LVG and install jumper W19 (3-4) to enable VT100 Mode.
Note: VT100 Mode runs on UART1 and UART2.
•
Connect the communications cable as shown in Diagram 15-1. Note: If you do not
require a full cable for your terminal, you can set up a partial cable by using only the
TXD and RXD lines. The control lines can be ignored by looping them back as shown
in Diagram 15-2.
•
Power on your TEK-AT4LVG and run VIP-UP Setup by hitting the CTRL and V keys
simultaneously, before or when you see the message "Press CTRL-V to enter TEKNOR
VIP-UP" at the top of the screen. On the VIP-UP screen, set the "VT100 & Serial
Download Speed" at 19200 BPS or 9600 BPS.
•
You must respect this protocol:
If you are running a terminal emulation program, these parameters must be set in it.
VT100 Mode
15-4
8 Bits
No Parity
Echo Off.