8.03.1 INSTALLING A FIXED SCSI HARD DISK
No additional hardware or drivers are necessary if no more than two IDE/SCSI hard disks
will be present in your system.
1 - Jumpers (Power Off)
Power off your computer.
The board's initial jumper settings should be kept in most cases, unless there is a conflict
with other devices you have installed. SCSI jumpers are shown below:
W18: Selects the SCSI IRQ Channel:
W22: Sets up the SCSI I/O Port Address:
W17 & W23: Selects the DMA channel for the SCSI Controller:
* Default setting
Installing IDE, Floppy & SCSI Devices
8-14