8.01.2 IDE HOOK-UP
For hooking up either IDE connector, a 40-pin dual row header signal connector is
required. This connector handles all command, data and status I/O lines. Its recommended
maximum cable length is 18-24 inches. It connects directly with the onboard 40-pin male
header connector at J3 or J8.
The following list includes approved vendors for the J3 and J8 connectors' mating parts:
Amp 746285-9 [optional strain relief: 499252-1],
Robinson Nugent IDS-C40PK-TG,
Thomas & Betts 622-4030 [optional strain relief: 622-4041].
(40-pin flat cable connector).
The drive itself can be mounted on any horizontal or vertical plane.
8.01.3 JUMPER SETTING
The W15 jumper, when set to Enabled will extend the current cycle on IDE
READ/WRITE transfers. Its setting appears below:
• W15: IOCHRDY Signal to IDE Interface:
* Default setting
Installing IDE, Floppy & SCSI Devices
8-6