Menu Commands - Teknor Industrial Computers TEK-AT4LVG Technical Reference Manual

12.04.1

MENU COMMANDS

TAG
UNTAG
BLOCK
MAKE BOOTABLE
NEWDIR
VFLASH Software
Use this function to select a file from the above file list.
Simply move the cursor over the desired field and press T on
your keyboard. The file will then be highlighted - indicating it
was selected. If you press T again, you deselect the file.
This function is used to deselect a chosen file from the above
list of files. To use this function, simply move the cursor over
the desired file and press U.
This function is used to mark a group of files for selection or
deselection. Move the cursor to the beginning of the first file
you wish to select and press on the B key (a "Ø" symbol will
be displayed after "Block" in the command area to remind you
that a block has been entered). Then, move the cursor to the
last file of the group and press B again (a "×" will appear
next to the "Ø" indicating that a block definition is now
complete). The block of outlined files are now ready to be
"Tagged" or "Untagged".
Choose this function to move files you wish to make bootable
into the FILE SELECTION area (to appear in the LIST OF
SELECTED FILES screen). The system will then prompt you
for the drive which contains the system files (Note that the
source should not be a Flash disk, since these are read-only
and write protected). Once the selected files are found, the
"Make Bootable" command will be changed to "BOOTABLE
DISK". This confirms that the Flash disk will be bootable.
This function lets you enter or exit a drive or directory. To
change directories, place the cursor at the desired entry and
press N. The listing will automatically change to the new
directory's content.
12-12