File Selection - Teknor Industrial Computers TEK-AT4LVG Technical Reference Manual

12.04 FILE SELECTION

Once you have selected the output, a file selection screen appears.
This menu allows the user to choose the files that will eventually make up the Flash disk.
Files can be chosen from the various drives on the system.
The top line in this menu gives size information about the Flash partition. SELECTED
FILES indicates how many files have been chosen up to this point. FREE SPACE TO
COPY indicates the available Flash space found, minus the space used up by the selected
files.
The largest block of information (center screen) is the FILE AREA. It lists the files in the
current directory.
Highlighted files are marked for copying to Flash devices.
Entries marked with a "<DIR>" extension indicate a subdirectory. When you select a
subdirectory, the first two entries are displayed as ". <DIR>" and ". . <DIR>". As with
DOS, "." refers to the current directory and ". ." to the parent directory. Thus, if you
enter a "Newdir" command on the ". . <DIR>" you will return to the previous directory.
Entries marked as "Drive A:" or "Drive B:" allow you to change drives/directories or to
select files. "DRIVE A/B: TO CHOOSE FILES" is used to select files. "DRIVE A/B:
COMPLETE COPY" is used to make an exact copy of a floppy disk to Flash. This last
function resembles a DOS DISKCOPY command. When this mode of transfer is chosen,
no other files can be sent along with the diskette files.
The bottom of the screen is dedicated to the MESSAGE AREA and MENU
COMMANDS.
The MESSAGE AREA gives indications and warnings with respect to file selection
operations.
The MENU COMMANDS begin with a highlighted letter or identifier which indicates the
key to press in order to execute the desired function. The following commands are
available:
VFLASH Software 12-10