Vflash Requirements - Teknor Industrial Computers TEK-AT4LVG Technical Reference Manual

12.01.3

VFLASH REQUIREMENTS

VFLASH is designed to operate in an IBM compatible environment.
The MS-DOS operating system has been successfully tested with VFLASH; MS-DOS
compatible operating systems such as DR-DOS and PC-DOS should therefore support
VFLASH. Operating systems such as QNX and OS-9000 are not supported by VFLASH
(other utility programs are available for such operating systems; please contact our
Technical Support department for more information).
If you intend to directly program Flash device on the TEK-AT4LVG, VFLASH must be
running on board.
If you need a remote computer to program Flash device on the TEK-AT4LVG (host), then
the board must be in Download Mode and VFLASH must be running on the remote
computer. A serial cable must be connected between the remote computer and either the
COM1 or COM2 port, as it would be in VT100 mode (the remote computer is cabled like
a VT100 terminal, see Section 15 - VT100 MODE).
F To run VFLASH properly, you need at least one floppy drive, 1 MB of DRAM,
MS-DOS® or PC-DOS (version 2 or higher) or DR-DOS (version 3. 41 or higher).
VFLASH Software 12-6