Teknor Industrial Computers TEK-AT4LVG Technical Reference Manual page 153

13.03.2 USING MEMCARD DIRECTLY FROM THE COMMAND PROMPT
If you use switches with the MEMCARD command directly from the command prompt,
you can format memory cards and check Flash memory cards for errors.
Syntax MEMCARD /FMT=drive: [/V=label]
MEMCARD /CHK=drive: [/F]
Parameters drive:
label
Switches /FMT=
/V=
card.
/CHK=
/F
Example 1:
To assign an entire memory card to drive D and specify the volume label CARD1, type the
following at the command prompt:
MEMCARD /FMT=D:/V=CARD1
Example 2:
To check partition E for errors, fix any errors that are found, and display the status of the
partition, type the following at the command prompt:
MEMCARD /CHK=E: /F
FLASH FILE SYSTEM II
Specifies the drive you want to format.
Specifies the volume label.
Formats the memory card partition associated with the
specified drive.
Specifies a volume name for the newly formatted memory
Checks the specified Flash memory card partition for errors
and displays a status report. If no drive is specified,
MEMCARD will check the current drive.
Fixes errors found on a Flash memory card. If this switch is
not specified, the errors are displayed but not fixed.
13-8