15.03
RUNNING WITHOUT A TERMINAL
The TEK-AT4LVG can boot up without a screen or terminal attached. However, if VT100
Mode is desired, but the terminal is to be disconnected, you must ensure the control lines
are in an active state. Failing this, the system may "hang" while waiting for the control
lines to become active. Wiring the system according to Diagram 15-2 allows the lines to
remain active. This does not apply if the VT100 jumper is not set.
Furthermore, you can run without any console at all by simply not enabling VT100 Mode
and by not installing a video card.
VT100 Mode
15-6