Configuration Section - Teknor Industrial Computers TEK-AT2 Hardware Reference Manual

CONFIGURATION
JUMPERS
The TEK-AT2 was designed to allow for minimal
hardware configuration.
The following Jumpers can be configured by using
shorting jumpers.
1
JUMPER STATE
Flash EPROM Type
W1(1-2) 29F040 Devices Only
W1(2-3) 28F010, 28F020 Devices Only*
RAM Battery Backup
W2 Open*
W2 Closed
Hard Disk Interface
W3 Open*
W3 Closed
Watchdog Timer
W4 Open
W4 Closed*
1
W2A is not used.
2
Devices expected to be available 4Q93
3
Vbatt must be installed to save configuration information
at power down.
SECTION 2
FUNCTION
2
3
NC
Vbatt
IDE Enabled
IDE Disabled
Disable
Enable
Do not install shorting jumpers.
* as shipped