Output Selection - Teknor Industrial Computers TEK-AT4LVG Technical Reference Manual

12.03 OUTPUT SELECTION

Once onboard or external Flash is selected, a second screen appears.
On the first line, the output selected will be displayed ("On board FLASH devices" or
"External FLASH devices via serial link").
The rest of the screen allows you to divide or partition the Flash disk according to your
needs. The default disk always starts at the beginning of the Flash space and the size is all
Flash selected. Therefore, a full bar will be displayed below the legend.
Directly below the bar is a BEGIN pointer. It shows where the Flash partition will begin.
The next line shows physical parameters such as the starting block ADDRESS and the
DISK SIZE of selected blocks. It also shows the minimal partition size you have available.
The minimal disk size can be altered by the /G:x option (for details on this option, please
refer to Section 12.05 - BATCH MODE).
Moving the BEGIN pointer with the left and right arrow keys allows you to select the
desired starting block (i.e., address) of the disk.
To set the size of the disk, type "E" and move the END pointer to the desired location for
the end of the disk by using the left and right arrow keys.
VFLASH Software 12-8