7.06
PS/2 MOUSE CONNECTOR
The board supports a mouse, through the PS/2 connector at J10 (#3 on Diagram 7-1).
With the PS/2 Mouse Cable (available from TEKNOR), this feature is compatible with the
standard IBM PS/2 mouse. The cable may be ordered by contacting our Sales department.
To use the mouse, the driver provided by the mouse manufacturer must be installed.
TABLE 7-5: PS/2 Mouse Connector (J10) - Pinout
Pin Number
Signal
1
MCLK
2
GND
3
MDATA
4
VCC (+5V)
The following list includes approved vendors for the J10 connector's mating parts:
Molex 22-01-3047 (connector),
Molex 08-50-0114 (crimp).
Installing and Working With System Components
7-13