Teknor Industrial Computers TEK-AT4LVG Technical Reference Manual page 152

If the card already has one MS-Flash partition, the following message appears at the
bottom of the screen:
This card has already been formatted.
Creating a partition will destroy all the data on the card.
Do you want to continue? (Y/N) [N]
Create a new partition only if you have backed up all the data that you want to save.
To continue, type "Y" and then press ENTER.
3. If the card is unformatted or has one large partition, the following message appears:
Do you want to use the entire card for MS-Flash? (Y/N) [Y]
To create and format one large partition, type "Y" and then press ENTER; to create
and format a partition that occupies only part of a memory card, type "N" and then
press ENTER.
4. This step is only required if you are creating a partition that will occupy only part of
the Flash device: Specify the size of the partition you want to create, and then press
ENTER. The minimum size depends on the amount of free space available on the
memory card. The number that appears on your screen is the largest amount of
available space.
5. Specify the number of spare blocks that MS-Flash should reserve for memory card
cleanup, and then press ENTER. The default is 1. Although reserving extra blocks
may speed up the memory card slightly, you will not be able to use the reserved blocks
for files. The default is recommended.
6. Specify a volume label for the partition, and then press ENTER. If you do not want to
specify a volume label, leave the field blank, and press ENTER.
FLASH FILE SYSTEM II 13-7