Powering Up The System - Teknor Industrial Computers TEK-AT4LVG Technical Reference Manual

5.06

POWERING UP THE SYSTEM

Before powering up your system, make sure that the battery jumper is intalled (Section
4.01).
1. Insert a bootable diskette in drive A to start your system with DOS.
2. Hit the DELETE key before or when this message appears near the bottom of the
screen: "PRESS DEL TO ENTER SETUP". This will bring you to CMOS setup.
- In Standard Setup, set the date and time.
- In other menu choices, set other options (if necessary).
3. Exit CMOS setup. The system will continue the boot procedure.
4. Once the boot procedure is completed, reboot the system to make sure everything
works properly.
If you should encounter a problem, verify the following items:
• Make sure that all connectors are properly connected. On the standard flat ribbon
cable used for the floppy connector, pin 1 is indicated by small red stripe. Verify that
this red stripe is located adjacent to pin 1 of the connector (On soldering side of the
board, connector pin 1 is designated by a square pad instead of being round).
• Verify your boot diskette. It must be a system disk and it must be in proper working
order.
• If the system still does not start up correctly, remove all the connectors except the
power cord and the video monitor, and try again (this configuration is the minimum
required to see if the board is working).
• If you still are not able to get your board up and running, contact our Technical
Support department for assistance.
Connecting and Powering Up the Board 5-8