Table of Contents
Advertisement
The following options identify disk or file parameters to be executed in BATCH mode.
/B/bootdrive:
Makes the disk bootable by transferring the bootable files from the 'bootdrive'
specified. Note that the source should not be a Flash disk, since these are
read-only and write protected.
/E
Performs an external transfer by serial link to the remote system. This switch
must be present in order to use any of the next three options (/RATE,
/COM2 and /R).
/rate
The value entered corresponds to the desired baud rate for transfer. Any one
of the following can be used: 300, 1200, 2400, 9600, 19200, 38400. It is set
at 19200 by default.
/COM2
This option instructs COM2 to be used instead of the default value COM1.
/R
Instructs VFLASH to reset the TEK-AT4LVG upon completion of download
operation. This is valid only in VT100 Mode. In Download Mode, the
remote system is always reset.
/S
Used to create a special disk or partition. This option precedes the starting
device number option (/#order) or the disk size option (/sizeK), or both.
/#order
Specifies the Flash block to be used as the starting point for a disk partition
(default setting is #1).
/sizeK
Specifies a special disk size, in KB, for the Flash disk. The default setting is
the largest disk size following the designated starting disk as selected in the
/#order option.
/V:volume label
This switch specifies a volume label for the disk to be created. This option
will report an invalid command line error if it is used while transferring a
complete copy of a floppy disk. Since it is acceptable to have spaces in a
volume label, do not place this switch before [drive:], [\directory] or
[destination] since VFLASH would not be able to determine when the label
ends and when these options begins.
VFLASH Software
12-23
Advertisement
Chapters
Table of Contents
