12.05 FILE TRANSFER
12.05.1
TRANSFER STATUS OF ONBOARD FLASH PROGRAMMING SCREEN
This screen displays each of the transfer operations in progress:
1. First, the Flash devices are erased. This operation can take some time to complete.
Only the Flash devices of the actual disk to be programmed will be erased, however.
2. The base system information is then transferred. This is followed by the file data itself.
3. The transfer in progress is displayed by XX%, and the actual file being copied is also
shown (unless a complete diskette copy is performed).
Restart the system if the disk is to be recognized by the TEKNOR BIOS extension.
Although rebooting is not necessary if Flash disks were not created, it is a recommended
procedure in all circumstances.
VFLASH Software
12-16