Table of Contents
Advertisement
11.02 OUTPUT SELECTION/FIRST SCREEN
To run VFLASH, simply type "VFLASH" at the DOS prompt and press ENTER.
The first OUTPUT SELECTION FOR THE TRANSFER screen appears with the
following options:
On board Flash devices.
External Flash devices via serial link.
Quit VFLASH and return to DOS.
Use the ↑ and ↓ keys to highlight the option and then press ENTER to select.
On board Flash Devices: Use this option when VFLASH is run on a board, with Flash
EPROM to be programmed directly on the board.
External Flash Devices via a Serial Link: Use this option when VFLASH is run from a
remote computer, or when your VIPer807 has no floppy or hard disks, or simply because
the data to transfer is on a different computer than the VIPer807 and Flash EPROM disk.
The transfer takes place via a serial link on COM1 (3F8H) or COM2 (2F8H), from the
remote computer to the VIPer807.
VFLASH Software
11-4
Advertisement
Table of Contents
